This functionality is only available for certain module packages. Info / Copyright

Dialog Settings: Interruption points

Special settings affecting each current project can be made for cross-references at interruption points.

The following dialog elements are available:

Display:

In this group box you can specify the following settings:

Display cross-reference:

If this check box is activated, the cross-reference will be displayed on interruption points.

Only display page names in cross-reference:

In EPLAN, an overview of all interruption points of the same name in the schematic project can be displayed at a specified source interruption point. You can use this setting to suppress the display of the column and line information in the overview: If this check box is selected, then the cross-reference is only displayed with the page names (without column and line information).

Note:

Activating or deactivating this check box is only possible if the check box of the Display cross-reference setting is activated.

Display full structure identifier in cross-reference:

If this check box is activated, the full identifier structure of the cross-referenced interruption point is displayed in the cross-reference in addition to page and / or schematic path information (row / column).

Note:

Activating or deactivating this check box is only possible if the check box of the Display cross-reference setting is activated.

Display target at pair cross-references:

If this check box is selected, then the target is displayed at pair cross-references, where the (first) target and then the cross-reference is displayed (for example, L1/ X1:1 /7.04).

Display target at star cross-references:

If this check box is selected, then the target is displayed at star cross-references.

Display target under the cross-reference:

If this check box is selected, then the target is displayed below the cross-reference.

Separator between name and cross-reference:

At interruption points, the page and column of a target arrow can be displayed. Here you enter the characters to be used to separate the interruption point designation from the page and column designations in the cross-reference.

See also