This functionality is only available for certain module packages. Info

Dialog Cable drawing display configuration set editor

The following dialog elements are available:

Annotation

In this main node, you find the following dialog elements:

AutoDimensions

In this main node, you find the following dialog elements:

Note:

In cases where there are multiple paths connecting the measured points, the dimension of the shortest path will be displayed. A wire or cable length stored in loops is ignored by the AutoDimensions function.

Balloons

In this main node, you find the following dialog elements:

Cable subparts

In this main node, you find the following subnodes:

In the subnode of each cable layer excluding Wire, you find the following dialog elements:

Cable tie

In this main node, you find the following dialog elements:

The cable tie symbol is always placed. It is the symbol in the first 2D window if the cable tie has multiple 2D windows.

Cable tie symbol

In this main node, you find the following dialog elements:

The cable tie symbol is an additional view of the cable tie. This additional view is the default 2D window for cable drawings if it is set accordingly.

Clip

In this main node, you find the following dialog elements:

Coating

In this main node, you find the following dialog elements:

Connectable object

In this main node, you find the following dialog elements:

The connectable object is always placed. It is the symbol in the first 2D window if the connectable object has multiple 2D windows.

Connectable object symbol

In this main node, you find the following dialog elements:

The connectable object symbol is an additional view of the connectable object. This additional view is the default 2D window for cable drawings if it is set accordingly.

Control point

In this main node, you find the following dialog elements:

Dimension

In this main node, you find the following dialog elements:

Label

In this main node, you find the following dialog elements:

The label symbol is always placed. It is the symbol in the first 2D window if the label has multiple 2D windows.

Label symbol

In this main node, you find the following dialog elements:

The label symbol is an additional view of the label. This additional view is the default 2D window for cable drawings if it is set accordingly.

Leading part

In this main node, you find the following dialog elements:

Loop

In this main node, you find the following dialog elements:

Part

In this main node, you find the following dialog elements:

Pin

In this main node, you find the following dialog elements:

Shrink tubing overlap

In this main node, you find the following dialog elements:

Note:

By default the inner and outer lines overlap. Negative offset values can be used.

Special components

In the subnode of each special component, you find a combination of the following dialog elements:

The special component symbol is an additional view of the connectable object. This additional view is the default 2D window for cable drawings if it is set accordingly.

Surface protections

In this main node, you find the following dialog elements:

In the subnode of each type of surface protection, you find a combination of the following dialog elements:

Symbol

In this main node, you find the following dialog elements:

Tables

In the subnode of each table, you find the following dialog elements:

Furthermore, the Content, Header, Title, Note, Grid line and Border line formatting can be edited here. A decoration can be defined in Decorations.

Wire

Wire symbol

In this main node, you find the following dialog elements:

Note:

For cable ties, clips, labels, and special components at least one of the Show drawing or Show symbol settings must be activated.