This functionality is only available for certain module packages. Info

Editing and Checking Bending Radius in Nailboard

The bending radius may only be added to control points in a nailboard derived from a workspace. It may, however, be added to control points of paths (of cable, surface protection, bundle, shield, insulator, etc.). Once a bending radius is added, the length of the path is changed accordingly.

Edit bending radius

  1. Select a control point.
  2. In the Advanced section of the properties panel use the Size field to change the size of the control point.
  3. Use the Bending radius field to change the size of the bending radius.

    The Original bending radius field displays the size of the original bending radius of the control point. This entry cannot be changed.

Check bending radius

  1. Select the View > Bending radius menu items.
  2. Click the (Check bending radii of bundles and cables) button on the main toolbar.

    When switched on, the bending radius of bundles, cables and any types of surface protection is checked. Segments for which the bending radius is smaller than the permitted limit are highlighted with a red dashed line.

Note:

Both commands are available in the nailboard.