Requirement:
- The file <EEC installation folder>\install\Tutorial\Step7\Tutorial_Step7.zip is unzipped in the same folder.
- EEC is started.
Based on the initial situation, various EOX files that contain the corresponding libraries must be imported.
- The model is empty, i.e., only the system libraries are available (also see Filter).
Import the following EOX files:
<EEC installation folder>\install\Tutorial\Mechatronic\Mechatronic.eox
<EEC installation folder>\install\Tutorial\Step7\Step7_Ui.eox
<EEC installation folder>\install\Tutorial\Step7\Step7_IOGenerator_Ui.eox
- The model contains T_Mechatronic_Architecture and T_Mechatronic_ModularSystem.
Import the following EOX files:
<EEC installation folder>\install\Tutorial\Step7\Step7_Ui.eox
<EEC installation folder>\install\Tutorial\Step7\Step7_IOGenerator_Ui.eox
Proceed as follows to import the required EOX files:
- Select File > Import....
The import wizard opens with the Import dialog:
- Select Model > Engineering Object Format (EOX Format).
- Press [Next >] to confirm.
- Select Add in the Mode panel.
- Select the required EOX file in the Source... section.
- Select the required libraries.
- Press [Finish] to confirm.
- Use to apply all incoming changes in the Synchronization view.
- If necessary, repeat Steps 1 to 8 and select the next EOX file that you need.