This functionality is only available for certain module packages.

Insert sockets in page

You must insert Sockets to ensure that the sensors can be placed by EEC when generating the page. Each socket defines a place on which a sensor (with plug) can be positioned. A macro can contain several sockets, but no more than one plug.

  1. Select Insert > Graphic > Text....
  2. Enter the following text for the socket:
#<Socket:Input1>
  1. Confirm with [OK].
  2. Position the text on the right above the PLC input, as shown in the following figure:

  1. Repeat the steps 1 o 5 for each further PLC input, and use ascending numbers for the socket (<Socket:Input2>, <Socket:Input3>, etc.). As an alternative you can copy the existing text several times by using Edit > Duplicate and adapting the texts.