Open topic with navigation

This functionality is only available for certain module packages. Info / Copyright

P003022: Invalid cable length

Cause

At a cable definition a negative value for the cable length was entered.

Solution

  1. Locate the cable definition line in the schematic by using the Go to (graphic) functionality from the popup menu in the Message management dialog.
  2. Open the property dialog.
  3. Enter a positive value in the Length field.
  4. Click [OK].
  5. Refresh the connections and then start a new check run.

Note:

Other invalid values, for example letters, are not accepted. Invalid values that include interpretable units, are automatically corrected. For example the input 2M turns into length 2 m.