This functionality is only available for certain module packages. Info / Copyright

Dialog Settings: General (Projects, Cross-references / contact image)

Using this dialog you can influence the display of cross-references and contact images on a project-specific basis.

The following dialog elements are available:

Display:

In this group box you can specify the following settings:

Separator:

In this group box you can specify the following settings:

Contact image table:

In this group box you can specify the following settings:

Page type / prefix:

To distinguish between the different cross-references, a prefix in the form of a desired character or character string can be defined for every type of cross-reference. In this table, you specify the various settings for cross-references to certain page types.

The marker text is displayed in the cross-reference at each main function.

Prefix for cross-reference (external):

Use this field to determine a prefix for the identification of the cross-reference type Cross-reference (external). The prefix can be any character or character string.

The "Cross-reference (external)" is generated in connection with the editing of subprojects. All functions and / or interruption points in the subproject which point to corresponding functions and / or interruption points in the original project automatically receive this cross-reference.

Display full structure identifier in cross-reference:

If this check box is activated, the full identifier structure of the cross-referenced devices is displayed in the cross-reference in addition to page and schematic path information (row / column).

Apply cross-reference abbreviation rules to DTs:

If this check box is selected, then the cross-reference abbreviation rules are not only used for the page information but also for the full DT.

Note:

Activating or deactivating this check box is only possible if the check box of the Display full structure identifier in cross-reference setting is deactivated.

Without page number:

If this check box is selected, the display of page numbers is always suppressed.

Suppress identical page:

If all identifying properties are identical, then selecting this check box allows the page number also to be suppressed.

Always display separator before the page:

This setting controls the display of the separator if the Suppress identical page check box above it is activated:

If the check box is enabled, the separator before the page will always be displayed.

If the check box is deselected, no separator is displayed.

Put cross-reference in parentheses:

To satisfy the GOST standard (a Russian national standard), cross-references must be placed in parentheses: Select this check box if this is required.

Auxiliary functions also refer to the device tag list:

If this check box is selected, cross-references are not only displayed at the main function, but also displayed at the auxiliary functions of a device that is distributed over the schematic. These cross-references also point to the device tag list in which the main device is listed.

Suppress document type separator:

If this check box is selected, then the document type separator that you defined in the page structure is suppressed in the cross-reference.

Rows and columns in cross-reference: Swap row and column information:

If this check box is selected, then the sequence of the display changes. The separators defined in the Separator group box are not changed by this.

See also