The bending radius can be set while placing surface protection or bundles in the command bar or later in the properties panel. The value used while placing the bundle or surface protection will be used for other new objects of the same type within that Workspace or Workdesk.

The bending radius is defined as the radius in which the control points of surface protections / bundles are shaped. To set the bending radius while placing surface protection / bundles, enter a value into the Bending radius field in the command bar. If you cannot see the Bending radius option in the command bar, change the Interpolation to Rounded corners.

To edit the bending radius of all control points at once, select the surface protection / bundle and enter a value into the Bending radius field in the command bar. To edit the bending radius of a specific control point, select the desired control point and enter the bending radius value.

To display the Actual bending radius value for a specific control point, select the desired control point of the surface protection / bundle. The value is displayed in the Actual bending radiusfield of the General section of the properties panel.