Cause
A wrongly formed saddle jumper was found in the project. You have defined a connection between terminals as a saddle jumper in the schematic or in the dialog Edit terminal strip. However, no value for the number of saddle jumpers is entered at one or both terminals.
A connection defined as a saddle jumper exists between the two terminals -X1:1 and -X1:2. Both terminals are "normal" feed-through terminals with two connection types. In the Connection point logic dialog no value or 0 was entered for the respective first function connection point at both terminals for the property Number of saddle jumpers.
Solution
- Call up the dialog Properties for the terminals respectively.
- Switch to the Symbol / function data tab and open the Connection point logic dialog by clicking the [Logic] button.
- In the Number of saddle jumpers field, enter a value for the respective function connection points that is greater than "0" (with regard to the example a 1 each at the first function connection point).
If required, start a new check run.