Cause

In the parts database to be checked a module was determined at which a subpart (so-called module position) is entered without DT and DT ID. The part number of the module is output in the placeholder <x>, the variant of the module in the placeholder <y>, the part number in the placeholder <z>, and the variant of the entered subpart <u> in the placeholder <u>.

Solution

1. In the parts management mark the line with the message in the Messages tab and select the Go to popup menu item for this line.
   
   The respective variant of the subpart entered at the module is marked in the tree of the parts management.
2. Bring the Module tab to the foreground.
3. Select a corresponding value in the property table in the DT column and / or in the DT ID column.
4. Click [Apply].
5. If required, start a new check run.
6. Close the parts management and perform a parts data synchronization.

See also

Tab Module