Cause

In the parts database to be checked a part was found where a "general" function definition is entered. The general function definitions are intended to be used in projects if the exact parts are not yet clear when the project configuration is carried out. Only the exact function definitions should be entered in the parts management.

Solution

1. In the parts management mark the line with the message in the Messages tab and select the Go to popup menu item for this line.
   The respective part is marked in the tree view of the parts management.
2. Bring the Function templates tab to the front.
3. In the Device selection (function templates) table click the entry in the Function definition column that contains the general function definition and click [...].
4. Select an exact function definition from the Function definitions dialog that is opened.
5. Click [Apply].
6. If required, start a new check run.
7. Close the parts management and perform a parts data synchronization.