P026058: Number of connections at the connection point <x> is larger than specified in the connection point pattern

Cause

For the connection point <x> of a part placement, the number of routing connections that can be wired to the connection point has been set in the connection point pattern, in the Max. number of connections column. However the actual number of routed wires connected to this connection point is higher than specified.

Solution

  1. Check the target wiring in the multi-line schematic, meaning the use of the connection symbols (T-nodes, angles, etc.), and correct it if necessary.
  2. If required, start a new check run.

Note:

If the permissible conductor type is specified in the connection point pattern of the source or target part and the conductor class is specified at the connection part, the number of connections for this conductor type / conductor class is compared.