Cause

In the parts database to be checked a part was found that has a replacement part but is not identified as a discontinued part.

Solution

Possibility 1

Identify the determined part as a discontinued part.

1. In the parts management mark the line with the message in the Messages tab and select the Go to popup menu item for this line.
   The respective part is marked in the tree view of the parts management.
2. Bring the Properties tab to the front.
3. Click (All properties).
4. In the property table open the hierarchy level General.
5. Activate the Discontinued part check box.
6. Click [Apply].
7. If required, start a new check run.
8. Close the parts management and perform a parts data synchronization.

Possibility 2

Remove the assignment of the replacement part to the determined part.

1. In the parts management mark the line with the message in the Messages tab and select the Go to popup menu item for this line.
   The respective part is marked in the tree view of the parts management.
2. Bring the Properties tab to the front.
3. Click (All properties) or (Filled properties).
4. In the property table open the Technical data hierarchy level.

5. Delete the replacement part in the Replacement part: Number field.

6. Click [Apply].
7. If required, start a new check run.
8. Close the parts management and perform a parts data synchronization.