All of the terminal clamps that can be assigned to a sensor are installed in the respective sensor.

1. Change to the Engineering perspective.
2. Open the Positionsensor_inductive component.
3. Drag the Terminal_PxC_3031212 component from the ECAD > ProPanel unit to the component editor three times.
4. Name the installed components as follows:

Old name	New name
Terminal_PxC_3031212	X1L+
Terminal_PxC_30312122	X1M1
Terminal_PxC_30312123	Input

5. For the Position parameter of the installed components, enter the value 300.
6. Repeat steps 2 to 5 for the Positionsensor_optical component.
7. Open the Pressuresensor component.
8. Drag the Terminal_PxC_3031212 component from the ECAD > ProPanel unit to the component editor two times.
9. Name the installed components as follows:

Old name	New name
Terminal_PxC_3031212	X1L+
Terminal_PxC_30312122	Input

10. For the Position parameter of the installed components, enter the value 300.