This functionality is only available for certain module packages. Info

Placing Surface Protections and Bundles in Workdesk

The procedure of placing surface protections or bundles in the workdesk is exactly the same as in the workspace. However, in the workdesk there is an additional option to use either a Cartesian or a polar coordinate system.

  1. Select the Cartesian coordinates option in the command bar, enter the coordinates, and click [OK] to place the control point.

    The command remains active.
  2. Or select the Polar coordinates option, enter the Length and Angle values, and click [OK] to place the control point.

    The command remains active.
  3. Use the Absolute or Relative option in the Measurement section of the command bar and enter the path diameter and bending radius in the corresponding fields.

    The bending radius defines the bend in the control points.
  4. Click [Finish] or the right-hand mouse button to place the surface protection / bundle. Or click [Cancel] to cancel placement of surface protection / bundle.

See also