This functionality is only available for certain module packages.

You are here: EEC > EPLAN Pro Panel > Placement > Coordinate specifications > Coordinate

Coordinate

By specifying the Coordinate parameter, objects are positioned in a list via the X and Y coordinates.

The coordinates are specified using the following syntax:

=List{<X-coordinate>,<Y-coordinate>}

When positioning on a mounting surface, e.g. when placing a wire duct on a mounting plate, the X and Y coordinates of handle V1 on the mounting plate refer to the V1 mounting point on the wire duct.

When positioning a device on a mounting rail, the X coordinate of handle M4 on the mounting rail refers to the M2 mounting point on the device. The Y-coordinate specification is ignored in this case.

The following diagram shows the result of specifying =List{20,0} for the Coordinate parameter of the Endblock component as the first component on a mounting rail: