This functionality is only available for certain module packages. Info

Panel Nailboard / Cable drawing source

The Nailboard / Cable drawing source section of the navigation panel provides information about the nailboard's / cable drawing's source data and its status in relation to this source.

For nailboards, the wire harnesses from the workspace and workdesk cannot be combined here. If the nailboard was created from a workspace, only the wire harnesses from a workspace can be added to it. If the nailboard was created from a workdesk, only the wire harnesses from a workdesk can be added to it.

For cable drawings, the cable units from both workspace and workdesk can be combined here.

The following data is displayed:

Property

Description

Name

Name of the source wire harnesses / cable units.

Source

Name of the source workspace / workdesk of the wire harness / cable unit.

Last update

Last update of the source workspace / workdesk.

Status

Shows whether the nailboard / cable drawing is up-to-date in relation to its source workspaces / workdesks. If it is not, you can use the Update nailboard / cable drawing function to synchronize the nailboard with the source data.

Last nailboard / cable drawing update

Date and time of the nailboard's / cable drawing's last update (by means of the Update nailboard / cable drawing function or the nailboard / cable drawing derivation process).

Electrical configuration

Source data configurations.

Display configuration

Name of the source's display configuration.

Note:

The text in the Name, Source and Last update fields will appear:

Add wire harness / cable unit

  1. Click the Add wire harness / Add cable unit button on the toolbar.

    A wire harness / cable unit selection dialog is opened. If the nailboard was originally created from a workspace, the wire harnesses from this workspace are available for selection. If the nailboard was originally created from a workdesk, the wire harnesses from this workdesk are available for selection. For cable drawings a cable unit from the workspace / workdesk can be selected.
  2. Select the desired wire harnesses / cable units and click [Finish].

    The nailboard / cable drawing source table and the nailboard / cable drawing itself are immediately updated after the wire harnesses / cable units have been added.

Remove wire harness / cable unit

  1. Select the desired wire harnesses / cable units in the Nailboard source / Cable drawing source panel. Multiple wire harnesses / cable units can be selected with the [Ctrl] or [Shift] key and the left-hand mouse button.
  2. Click the Remove wire harness / Remove cable unit button on the toolbar.

    A prompt for confirmation is displayed.
  3. Click [Yes] if the wire harnesses / cable units are really to be removed.

    The selected wire harnesses / cable units are removed.