This functionality is only available for certain module packages. Info

Bending Radius

During the placement of any type of surface protection and bundle, the object's bending radius can be set. It can, of course, also be changed later on. The bending radius is available only in the workdesk environment.

The bending radius is defined as the radius in which the control points of surface protections / bundles are shaped. To determine the bending radius during surface protection / bundle placement, simply enter a value into the Bending radius field in the command bar.

To edit the bending radius of all control points at once, select the surface protection / bundle and enter a value into the Bending radius field in the command bar. To edit the bending radius of a specific control point, select the desired control point and enter the bending radius value.

To display the Actual bending radius value for a specific control point, select the desired control point of the surface protection / bundle. The value is displayed in the Actual bending radiusfield of the General section of the properties panel.