Connection symbols can be exchanged using the "Draw over" function.
Preconditions:
- You have opened a project.You have opened a project page in the graphical editor.
- The page contains connection symbols.
- You selected the Connection symbols with prompt check box in the user settings (Options > Settings > User > Graphical editing > Connection symbols).
- Select the menu items Insert > Connection symbol.
- Select the connection symbol you would like to insert from the menu that opens.
- In the subsequent dialog select the desired target-specific variants for T-nodes, double junctions, and jumpers.
- Select the Draw as point check box if you want the connection symbol to be drawn as a connection point.
- Click [OK].
- If required, hold down the [Ctrl] key and move the mouse to page through the previous variants.
- With the left mouse button click the insertion point of an existing connection symbol in order to place the new connection symbol on this location.
- Proceed in a similar manner for all additional connection symbols.
- End the action via the Cancel action popup menu item or via the [Esc] button.
The original connection symbol is replaced by the new one. The following restriction applies to interruption points: An interruption point can draw over an angle (a T-node) but not vice-versa.
Note:
As soon as you double-click the connection symbol with the left mouse button, a dialog containing the list of variants for the selected connection symbol opens. Select a variant to replace the current variant. This does not apply to angles.